/*

  e-Gizmo Water Level Sensor
  Sample Codes

  Reads the Digital Output on pins and prints the result to
  the serial monitor.

  by
  e-Gizmo Mechatronix Central
  November 26, 2014
  http://www.e-gizmo.com

*/

// the setup routine runs once when you press reset:
void setup() {
  // initialize serial communication at 9600 bits per second:
  Serial.begin(9600);
}

// the loop routine runs over and over again forever:
void loop() {

  // read the output on digital pins:
  int Level1 = digitalRead(5);
  int Level2 = digitalRead(6);
  int Level3 = digitalRead(7);

  // print out the value you read:s
  Serial.print("Level 1 =  "); Serial.print(Level1); Serial.print("   ");
  Serial.print("Level 2 =  "); Serial.print(Level2); Serial.print("   ");
  Serial.print("Level 3 =  "); Serial.print(Level3); Serial.println("   ");
  delay(1);//delay ms
}