e-Gizmo

Detects objects as far as 72mm (2.8 inches) from the sensor face. Infrared beam makes it relatively insensitive to ambient light and color (of target object). Applications includes non contact object detection and collision sensor for mobile robots.Demo Video :Specifications :Power Input5VDCDete..

e-Gizmo Sound Activator Switch were you can control your devices by using a snap of you finger or clap to make a noise or sound. Its very useful requires only +5VDC for the supply input and an output pin connection for high or low logic control. Compatible in all gizDuino boards. Specifications :Pow..

The EGRF-433A1 transmitter and receiver pair is a low-cost solution for radio wireless control application circuits. Operating at 433MHz ISM frequencies, this low power radio system has a remote operating reach of more than 100 meters in open field (125 meters/370 ft being typical) . The control dis..

The EGRF-433A1 transmitter and receiver pair is a low-cost solution for radio wireless control application circuits. Operating at 433MHz ISM frequencies, this low power radio system has a remote operating reach of more than 100 meters in open field (125 meters/370 ft being typical) . The control dis..

UHF-EX is a transparent wireless UART transceiver with 100mW RF output. This RF power allows a useful control range of more than 500m (unobstructed line of sight LOS range can reach 700m).Specifications :Power Input5V/3.3V jumper selectable Frequency Range431.1 MHz – 437.3 MHz Channel Sepa..

gizDuino compatible card shield for SD/MMC card read and write applications. Two card sockets allows user applications to work on two SD/MMC at a time. Uncommited I/O pin gives user the freedom to assign I/O to his/her liking. Specifications :Power InputPowered via gizDuino (Arduino Clone) SD-C..

Our new low cost Organic LED (OLED) Shield is a 2"" diagonal, 128x160 pixels Graphic Display. The shield is usually paired with an SD Card shield for image display. It includes brightness, contrast, and color adjustments. One can make a DIY cellular phone using this shield and many more applications..

This LED Matrix Drivers used in conjunction with our gizDuino (Arduino compatible) controller and LED dot matrix display kit to build a full function LED dot matrix display system. Specifications :Power InputPowered via gizDuino/Arduino boardMax LED Matrix Board Driving CapacityUp to 5 Cascaded Boar..