All Products

CMOS BCD to 7 segment Latch Decoder Driver- Low-cost Generic/Chinese Brand- Generally suitable for non-critical, DIY, hobby projects.- IQC sampled for logic function tests.These Chinese brand logic ICs are sold at a much lower cost. We tested (by lot sampling) and verified the logic functions of the..

CMOS Decade Counter with 10 Decoded Outputs- Low-cost Generic/Chinese Brand- Generally suitable for non-critical, DIY, hobby projects.- IQC sampled for logic function tests.These Chinese brand logic ICs are sold at a much lower cost. We tested (by lot sampling) and verified the logic functions of th..

With the imminent sunsetting of 2G networks, 2G modules, such as SIM800L, may no longer work in the Philippines.Air780E 4G module can be a cost effective replacement for the aging 2G modules.- 4G Cat-1 means it will work with common LTE SIM Card (Tested with Globe and Smart SIM).- Support SMS functi..

Microcontroller friendly thermal printer with Serial TTL Level communication interface.Model no: T7-SPrinting Media: Thermal PaperPaper Width: 58mmPrinting Width: 48mmPaper Capacity: 57xd30mm (d40mm maximum)Communication Interface: UART TTL and RS232 Level Power Supply: 5V-9VPrint Speed: 70mm/sNote:..

The E32-900T20D is a wireless transceiver module operating in the 862-931MHz band. Its powerful 20dbm (100mW) transmitter and use of LORA Spread Spectrum Technology enable a line-of-sight LOS transmission up to more than 5km, while meeting the emission standards guidelines set by the FCC.Power Suppl..

This (unused surplus) ETR+3048 is a telecom grade (i.e. High quality + High Reliability) power supply unit has a small form factor but big 3000 watt output capability.The unit is shipped with the output fixed at approximately 54VDC, making it usable in various 48V based DIY projects, such as batter..

This product can charge up to 60 devices simultaneously at 1.16A charging current per port. Each port are individually current limited to a little more than 3A, hence charging current > 1.16A is possible if the device being charged demands for it and the charging devices numbers less than 60.Will wo..

This product can charge up to 20 devices simultaneously at 0.7A charging current per port. Each port are individually current limited to a little more than 3A, hence charging current > 0.7A is possible if the device being charged demands for it and the charging devices numbers less than 20.Will work..

This product is a motorized linear actuator that can be used in light duty DIY projects not requiring precision positioning. It has a powerful DC motor that can be speed controlled by simply varying the supply voltage within its working range.**Attention: Motor and leadscrew assembly are refurbished..

Good Quality RS395 Type DC Motor usable down to 5VDC. With performance enhancing flux yoke to minimize magnetic leakage, keep the magnetic field inside of the motor where it is needed most.Nominal Voltage: 16.2VDCRated Power: 50WOperating Voltage: 5V-16.2VDCNo Load RPM: 11600rpm @ 12VDC, 5640rpm @ 6..

Basic functions PWM charge controller for DIY Solar Projects.- LCD Display- Built-in Short Circuit, Open Circuit, Reverse Polarity, and Overload ProtectionBattery Voltage: 12V/24V AutoselectMax PV Panel: 120W @ 12V, 240W @ 24VMax PV Input Voltage: 50V (2x 19.5V Solar Panel)Max Charging Current: 10AP..

Precision LM Guide with two SSR15 Carriage. THK Made in JapanRailing: 15x12.5x518 WxHxL mm approx.Weight: 934g approx.Important: A carriage may have 1 or 2 roller balls lacking. If this presents a problem to you, please contact us first before checking out the item.Note: This item is a quality refur..