Menu
Your Cart

I/O Subsystems

Brand: e-Gizmo
-Genuine 2x Matsushita Automotive Qualified Dual relay for a full 4 channel relay function- Automotive relays can take a lot of punishment during operation (e.g. Vibration, shock, high temperature, etc.) and keep going. The mentioned conditions can kill low quality relays in a short time.- 12V Coil..
₱169.00
Delay ON/OFF Relay Module with Optoisolated Trigger inputSupply Voltage: 6-30VDCTime Delay: 0.1s to 1 hour in 8 rangesLoad Capacity: 10A @ 250VAC or 30VDCStandby current: 6mA Typ Downloads : Manual Guide Downloads..
₱177.00
5V Relay module with 10A contact- Buffered input (Active High)- LED Indicators- NO/NC Terminals- 220VAC Rated ContactsCompatible with 3.3V to 5V logic drive (eg. gizDuino, Arduino, Raspberry Pi)..
₱54.00
4 Channel 5V Relay module with 10A contact- Opto isolated input- LED Indicators- NO/NC Terminals- 220VAC Rated ContactsCompatible with 3.3V to 5V logic drive (eg. gizDuino, Arduino, Raspberry Pi)..
₱197.00
Analog output 2-axis Thumb JoystickWith push switch output- 5 pins terminal configuration: +5V GND VRX VRY SW Specifications : Power Input 5VDC Output Analog : X-Axis : 0 - 1023 Y-Axis : 0 - 1023 Button : 1 || 0 Downloads : Hardware Manual Download Sampl..
₱48.00
8 Channel relay board- Optocoupler isolated drivers- 5V coil voltage- 10A at 220VAC/32VDC  SPDT Contact- LED Indicators for each channelCompatible with logic driving 5V and 3V (e.g. Arduino, Raspberry Pi)..
₱275.00
2-Ch Relay Module 2-Ch Relay Module
-17 %
5V 2 Channel Optoisolated Relay ModuleWorking Voltage: 5VRelay Contact Ampacity: 10ATrigger Level: Active LowCompatible with 3.3V to 5V logic drive (eg. gizDuino, Arduino, Raspberry Pi)..
₱75.00 ₱90.00
5V Relay module with 10A contact- Buffered input (Active Low)- LED Indicators- NO/NC Terminals- 220VAC Rated Contacts..
₱54.00
Brand: e-Gizmo
Relay Module 5V 10A with transistor driver- 5V Relay coil Voltage- 10A 220VAC NO/NC contact- Screw terminals- 3V to 5V drive voltageThis Relay module uses a genuine, good quality relay with safety approvals (UL/VDE/CUL)..
₱85.00
Brand: e-Gizmo
12V coil 220V 20A load Relay ModuleBuffered relay, active High inputInterfaces directly with a gizDuino/Arduino boardRelay qualified by Safety agencies (UL/CSA/TUV) Wiring : Note: Only 1 device is allowed on this module. On the wiring diagram shows,  You may use the Terminal Block for 5 A Loa..
₱175.00
4 ch Solid State Relay Module5V control input, Active low trigger2A 240VAC Normally OpenCaution: AC only output. Not applicable for DC output switching...
₱382.00
8-Channel 5V Relay Kit
-21 %
8-Channel 5V Relay Kit Highly reliable NEC DIP relay with 5V coil voltage.SDPT Contact capable of carrying 2A each. Opto isolated input drives protects your controller from harmful relay "kicks". Logic Low activating input...
₱380.00 ₱480.00
Showing 1 to 12 of 25 (3 Pages)