e-Gizmo RFID Card Reader 2 can be used as a stand-alone RFID Card Reader, or can be connected to a host controller (e.g. gizDuino/Arduino). It can store up to 100 RFID cards assigned with a unique 7-bit address each. A host controller can detect and read the card two ways: via its 7-bit address port or UART port. Additional functions are available when using the UART port.
On board key functions includes "Enroll & Delete","Execute", ""Serial Connection"" for monitoring, LED indicators, and Output connection for (ON/OFF ) other devices.
Specifications :
| Power Input | 7.5 to 9V DC (DC Jack)
5VDC (P2)
|
| On-board IC | ATmega168 |
| Address Bit Amount | 7 bits |
Maximum cards that can be registered
| 100 (from internal memory alone)
|
| Radio Frequency | 125KHz |
| RFID Card Type | 64bit |
Maximum Detection Range
| 3 inches parallel to the coil
|
Device Dimensions
| 46X64mm |
Features :
| A Stand-alone RFID Card Reader |
In system 2 seconds delay after tapping to avoid data traffic
|
| It can read and show the actual Serial number indicated on the card |
| Can only read passive type RFID-Tags |
| Ease of card reading through distant detection |
| Detects and discerns between registered and unregistered cards |
| Internal memory can register up to 100 RF I.D. cards |
| Easy "Enroll & Delete" user with commands |
Downloads :
>
-200x200w.JPG "TFT LCD Shield 2.4\" with MicroSD Interface")
-200x200w.jpg "gizDuino + with ATmega644")
